如何使用labview 在USB介面下傳送C code

LabVIEW
1

各位大家好:我想要請問一下，最近剛接手一台液晶控制器usb介面是利用c語言去控制的，但是我主要的系統是用labview去控制的，想請問這要如何在labview中利用usb介面傳送c語言給這一台控制器? 感謝各位!!!

2

請問你的機器的詳細型號是甚麼，請提供。



3

你好:我是用液晶控制器LCC25，然後我有去它的公司網站查了一下，這是他們工程師

A response from Tor at Thorlabs to binupt: Thank you for your request. The LCC25 can be controlled via the ASCII commands on page 10 of the manual. First you must run the CMD command to load the USB/Serial protocol. You get that executable after you install the Thorlabs software. Check to see what virtual COM port was assigned, then set up a serial RS232 protocol to that port and use the ASCII commands found in the manual. Its typically a write/read protocol.

First you must run the CMD command to load the USB/Serial protocol.------->請問這個要如何架設?

THANK