Vision Builder AI 2.6.1 轉出Labview 程式的問題?

LabVIEW
1

各位先進們, 小弟初入貴寶地, 有個問題一直找不出答案... 小弟使用了VBAI 2.6版, 也貫了Labview8.0 為何要將VBAI 的程式轉出LV時, 仍會出現無法轉出的畫面? (LV7.1也是一樣..)

![](upload://ifJeK0qlPv6Jds2l7woUxY8ElcC.jpeg)

2

是不是要先安裝Vision7.1以上，才可以將VBAI2.6.1轉成LabVIEW檔?

你有安裝Vision7.1嗎?

3

Hello, 張大哥, 我有貫Vision assitant 7.1, 不知是不是安裝順序差別造成的? 我安裝順序是VBAI --> Assitant -->LV

4

Problem solved !!

Generating Code for LabVIEW 8.0 in Vision Builder for Automated Inspection

Primary Software: IMAQ Vision Builder for Automated Inspection
Primary Software Version: 2.6.1
Primary Software Fixed Version: 3.0
Secondary Software: N/A

Problem: When trying to generate code for LabVIEW 8.0 using Vision Builder for Automated Inspection, I receive a pop up looking for VIs. Why is this?

Solution: If you attempt to migrate an inspection to LabVIEW 8.0 from Vision Builder for Automated Inspection (VBAI) version 2.6.1, it is possible you will receive pop up dialogs requesting the location of necessary VIs. Should you cancel these dialog messages, VBAI will generate code, but that code will not execute due to missing VIs. In order to enable the ability to migrate inspections from VBAI 2.6.1 to LabVIEW 8.0, you will need to mass compile the VBAI folder. The steps to perform this process are listed below.

  1. Launch LabVIEW 8.0
  2. Select Tools»Advanced»Mass Compile...
  3. Navigate to and select the "C:\Program Files\National Instruments\Vision Builder AI 2.6\LV\SubVIs" directory.
  4. Select OK and wait for compile to complete

After this process completes, you should be able to Migrate your inspections to LabVIEW 8.0 without any problems.

Related Links: KnowledgBase 3FBHAIB1: Vision Builder for Automated Inspection Installer FAQ

Attachments:


Report Date: 2005/10/06
Last Updated: 2005/10/11
Document ID: 3Q5FNUV3

function comments() {
var com_URL = “”;
window.location = com_URL;
}

5

安安

你的labview與vision builder應該都符合規定..

那請問你的image (NI-IMAQ)的版本呢?

我目前的版本為: labview-7.1   IMAQ vision-7.1  NI-IMAQ 3.0

你參考一下 希望對你有幫助唷~